SPONSORED BY:

"PROJECT VIPER"

MOD LIST

MOTOR (Built by Abbott Racing Heads)
Diamond Forged piston 8.5:1 c/r w/rings and wrist pins
Forged L32 Connecting Rods
ARP studs, all around
ZZ Performance 4 layer MLS .065 head gaskets
Manley Custom valve's
Comp Cams Custom Grind, 224*/215* .336/.334 116LSA
Comp Cams Hydraulic Roller Lifters
MANLEY 150lb Valve Springs
Comp Cams Titanium Retainers
Comp Cams Push Rods
Comp Cams 1.7 Pro-Magnum Full Roller Rockers
Double Roller Timing Chain
Federal Mogul Main Bearings
Federal Mogul Rod Bearings
Federal Mogul Cam Bearings
Oil PSI kit to 80 PSI at WOT
New oil pump kit

PCM / Electronics
HP Tuners PCM Programmer with EIO
Greddy Black Profec B-Spec II electronic boost controller

FUEL
65 lb/hr injectors
Racetronix Walbro In tank Pump 255 LPH with Rewire kit

Induction
Force Fed Fabrications Forward Facing Header Turbo kit
Master Power Super 70 Trim .70 cold/.68 hot "P" Trim
36x12x3.5 Intercooler with 3 inch inlet and outlet.
K&N air filter

Exhaust
QTP 3inch Electric cut-out

Ignition
NGK TR7 Plugs PN 3346

Gauges
Boost
Fuel PSI
Digital RPM gauge with LED shift light built in
IFJO Wideband with NTK sensor

Outside
Light black outs all the way around
Viper yellow with black racing stripes
"Camaro" rear inserts
3800 Decals
30th Ann. Decals

Inside
Custom painted Yellow by me
White face/ reverse glow gauges
Corbeau adj. racing seat (yellow)
Corbeau black 5-point harness.
Corbeau seat mounting brackets.
Autometer 3 gauge pillar pod

System (Removed most of it now)
Panasonic 60w * 4 w/ 3dot matrix display
Kicker components

Transmission (swapped out the broken 5 speed)
Rossler Stage III 4L60E
Precision Industries TQ Converter
4600 Stall with 2.5str

Drive Train
Prothane Tranny Mount
Z28 rear axles/brakes
LS1 Drive Shaft
Eaton carrier With 3.42's
MAC Cover to help hold the rear in one piece.
Mickey Thompson Et Drag Radials 255/50-16 on stock Firebird wheels (back up set)
Prostar 15x3.5 Shinnies and 15x10 rear wrapped in 325/50-15 Mickey Thompson ET Drag radials.

 Suspension
PA Racing K-Member
KYB AGX 8 way Adj. shocks on front and rear
Spohn 8 point roll bar. (Door bar's not installed yet)
Spohn LCAs and new bolts
UMI Cross-brace mounted TQ Arm

Brakes
Hawk HPS pads both front and rear.
Cross drilled/slotted rotors both front and rear.
Stainless Steal brake lines  

Sorry this page broke this is text only till i fix everything

01/16/2009 08:52:34 AM