Coil Relocation

SPONSORED BY:

"PROJECT VIPER"

If you have 3800 Camaro and DIS-4 you know the interface units give you no clearance. This is my solution to the problem.

First while you have the coil packs off remove the IGN control module form the plate, remove the 2 nuts holding the plate and finally the plate. Second fit the plate were the IGN MOD well still fit but move it to the front of the car some. Finally drill a new hole in the plate and install.

Now you can see were I had to drill you could use a washer if you want but it is not needed. I was worried about it coming lose but after 3000 miles its doing just fine :)

For other helpful guide's from TB mod to supercharging to changing out rockers visit "grayman's" site!!